Paderno

Seven steps to one perfect pot for you!

STEP 1
Paderno cookware starts as a sheet of top quality 304 stainless steel. We cut the sheet into squares and then trim them into circles. These circles are then pressed into the shape of the pot.

STEP 2
We carefully trim the excess material from the pot and sand down all sharp edges. This provides the perfected no drip lip and gives our cookware its smooth, elegant edges.

STEP 3
Through a special bonding process we apply a prepared aluminum disc to the bottom of the pot. This is what gives the fast, even heat conduction of every piece of Paderno. Without this you wouldn't be so hot on our pots

STEP 4
We take particular pride in the polishing of our cookware. Each pot must pass through 5 polishing stations to give it that mirror-like finish. Our handles alone take 4-6 hours just to polish!

STEP 5
Next, we weld our handles to the cooking vessel. This top of the line spot weld is second to none. This process is what keeps your handle from falling off for at least 25 years.

STEP 6
Once the pot is completed we then put it through our large wash plant to clean all dirt particles from the stainless steel.

STEP 7
We then take one final inspection by our quality control department prior to packaging.